DENAKOR P - quickly-drying anticorr. dispersion primer [ Výrobek nebo zboží k prodeji ]

DENAKOR P - quickly-drying corrosion inhibitive dispersion primer -

DENAKOR P is a one-component water based paint formulated on the bases acrylate dispersion. The paint contains further an appropriate combination of corrosion preventing reactive and traditional anorganic pigments, fine fillers, dispergation, soaking, and biocidal agents, coalescents and other additives suitably modifying the properties of the coating composition. It contains no aromatic thinners and in comparison with classic paints it has minimum effects on the health and environment when being applied. The tools are cleaned by water only and the thinned residues of the composition are degradable biologically.

Use: DENAKOR P is used as priming coat for steel segments and structures and with regard to its quick drying and increase in strength it qualifies mainly for workshop application in the metal processing industry. As top sealing coat the DENATOP dispersion enamel or the two-component DENAPOX E or DENAPUR are used. Other types of top coating have to be consulted with the manufacturer or experimentally tested.

Properties:
Density: 1,2 - 1,3 kg per liter
Weight solids: 48 -58 %
pH: 8 - 10
Volume solids: 30 - 43 %
This paint features very quick-drying, increase in strength, and tack-free film, good adherence to the subgrade and excellent antirusting properties.

Surface preparation: The coat shall be applied onto a subgrade free of rust and mechanical and greasy impurities. Short blasting is recommended as the most suitable way of making the surface clean.

Paint application: The paint is applied by brush, roll, by spraying or dipping in one or two layers in a time interval of 4 hours at least. It is recommended to discuss in advance the method and conditions of application in order that a paint supply tailored to the concrete conditions can be prepared. The temperature both of air and subgrade must not drop below +15 °C during application and drying. At lower temperatures the paint does not produce a perfect film and both the quality and lifetime of the coating decrease.

Theoretical spreading rate: The spreading capacity is 5 - 7 m2 of 1 kg for one coat.

Tinge: The composition in the consistency as supplied is ready for direct application and should not be water thinner prior to application. Only in exceptional cases the paint may be thinned by a small amount of water - maximum up to 3 % by weight. It is supplied in white, grey, and redbrown shades, other shades have to be agreed upon with the manufacturer.

Packaging and storing: Packing in plastic or metal sheet packages of 0.8 - 200 kgs weight. The product should be stored in its original packages under +5 to +25 °C at places protected against direct sun radiation and against sudden temperature fluctuations. The shelf time is 12 months from the date of manufacture.

Safety and hygiene: DENAKOR P is a non-toxic and as supplied non-combustible composition. It contains no pigments on the basis of heavy metals and Cr6. It is recommended to treat the skin expected to come into contact with the paint with a suitable protective cream, protective aids should be used and the principles of personal hygiene adhered to. When working indoors the working place has to be ventilated. When larger areas of skin get stained they should be washed with soap and water, when eyes get affected they should be splashed out by a stream of clean water and in more serious cases a physician should be seen.

INFORMATION: http://www.denascolor.cz